[. . . ] W10526075A RANGE SAFETY Your safety and the safety of others are very important. We have provided many important safety messages in this manual and on your appliance. This symbol alerts you to potential hazards that can kill or hurt you and others. All safety messages will follow the safety alert symbol and either the word “DANGER” or “WARNING. [. . . ] Before sliding range into its final location, check that the antitip bracket will slide under the range and onto the rear leveling leg prior to anti-tip bracket installation. Drill two ¹⁄₈" (3 mm) holes that correspond to the bracket holes of the determined mounting method. Use a ¹⁵⁄₁₆" combination wrench and an adjustable wrench to attach the flexible connector to the adapters. Using the Phillips screwdriver, mount anti-tip bracket to the wall or floor with the two #12 x 1⁵⁄₈" screws provided. If connected to LP, have a qualified person make sure gas pressure does not exceed 14" (36 cm) water column. examples of a qualified person include: licensed heating personnel , authorized gas company personnel , and authorized service personnel. Apply pipe-joint compound made for use with LP gas to the smaller thread ends of the flexible connector adapters (see B and G in the following illustration). Attach one adapter to the gas pressure regulator and the other adapter to the gas shutoff valve. If burner caps are not properly positioned, surface burners will not light. Failure to follow these instructions can result in death, fire, or electrical shock. Visually check that the rear range foot is inserted into the slot of the anti-tip bracket. IMPORTANT: If there is a snapping or popping sound when lifting the range, the range may not be fully engaged in the bracket. Check to see if there are obstructions keeping the range from sliding to the wall or keeping the range foot from sliding into the bracket. Verify that the bracket is held securely in place by the mounting screws. Slide the range forward, and verify that the anti-tip bracket is securely attached to the floor or wall. Slide range back so the rear range foot is inserted into the slot of the anti-tip bracket. 1 cm) from the mounting wall, the rear range foot may not engage the bracket. Slide the range forward and determine if there is an obstruction between the range and the mounting wall. If you need assistance or service, refer to the “Assistance or Service” section of the Use and Care Guide, or the cover or “Warranty” section of the User Instructions, for contact information. Repeat steps 1 and 2 to ensure that the range foot is engaged in the anti-tip bracket. 3 cm) off the floor without resistance, the anti-tip bracket may not be installed correctly. Do not operate the range without anti-tip bracket installed and engaged. [. . . ] Install anti-tip bracket to floor or wall per installation instructions. Slide range back so rear range foot is engaged in the slot of the anti-tip bracket. Failure to follow these instructions can result in death or serious burns to children and adults. Locate the access panel at the rear of the storage drawer compartment. [. . . ]